Detailed Product Description

Installation:
 1. Begin separation of the messenger wire from
   the cable using the end-edge of the SC02MFA-               

   SS Drop Clamp.
Note: Never   use   a   knife   or   other   sharp   tool   to
        separate messenger & cable.
2. Fit   the  cable   and   messenger      wire  into  the
   SCO2MFA-SS   Drop   Clamp   as   shown,   so   that
   the Clamp Bail is between the two.
3. Grasp the separated end of the messenger and
   cable with one hand and grip the Clamp Body, as
   shown,   with   your   other   hand.   Then,   pull   the
   SC02MFA-SS back, in a straight line, separating             
   the  length  of  messenger  wire  needed  to  make
   the wrap; about 15 to 18-inches.
4. Pull the messenger wire around the center of the
   bearing   surface   as   shown,   toward   the   rear   or
   drop-side of the Clamp.
Note: If at the house end of the drop, this will be
        done while tensioning or sagging the drop.          
5. Serve the messenger wire through the L Slots
   and   begin   the   wrap   about   the   SC02MFA-SS
   body, as shown.
6. Continue  the  messenger  wire  wrap  for  two  full
   turns.
7. Serve the messenger wire through the L Slot,
   as shown, to the drop-side of the SC02MFA-SS
   and cut the excess wire away, or ground it to the
   strand.